Mitsubishi Electric MELSEC iQ-R Series User Manual page 19

6.
Configure the settings as follows.
• Set "IPv4" to "Manual IP and manual DNS", and set desired network parameters. Set the IP address and subnet mask in
the same segment as the programmable controller and network storage.
• Turn off "Automatic date and time" and set the time manually.
• When an NTP server is present in the same segment as the programmable controller, turn on "Automatic
date and time" and perform the time synchronization setting from the NTP server. In that case, the time
setting FB is not required.
• If the "Date and time" settings section does not appear, set them after completing the initial start-up settings.
7.
If the access to the web server is denied due to the network settings of the network camera, set the IP address of the
personal computer again so that it is set in the same segment as the network camera set in step 6.
8.
Enter the IP address of the network camera in the web browser, and access the web server again.
4 INSTALLATION AND SETTINGS
4.1 Network Camera Settings
4
17