Chapter 5: Card Bring-Up And Validation; Running Lspci - Xilinx Alveo U200 Getting Started

Data center accelerator cards

Hide thumbs Also See for Alveo U200:

Getting started (53 pages)

Getting started manual (51 pages)

User manual (26 pages)

Table Of Contents

Table of Contents

Card Bring-Up and Validation

After installing the XRT and deployment platform, the card installation can be verified using the

following commands, which are explained in more detail below.

• lspci

• xbmgmt flash --scan

• xbutil validate

The lspci Linux command is used to validate the card as seen by the OS, as was done when

installing the card.

The second and third commands use the Xilinx

during the XRT package installation. These utilities include multiple commands to validate and

identify the installed card(s) and report additional card details including memory, PCIe

name, and system information. See Vitis Unified Software Platform Documentation: Application

Acceleration Development (UG1393) for a detailed list of commands.

Set the environment to use the utilities by running the following command. Note that the

command is dependent on the command shell you are using.

Use the following command in csh shell:

$ source /opt/xilinx/xrt/setup.csh

Use the following command in bash shell:

$ source /opt/xilinx/xrt/setup.sh

Running lspci

1. Enter the following command:

$ sudo lspci -vd 10ee:

UG1301 (v1.5) June 3, 2020

Getting Started with Alveo Accelerator Cards