Initializing (Resetting) - Epson EB-E01 Service Manual

EB-E01 series

4.1.3 Initializing (Resetting)

Initialization of the following information can be done by performing the procedure below when the AS menu is displayed.
Type
Operation
Item
Total Operation Time
Lamp Operation Time
(3D/H/M/L/UL)
Lamp ON
Lamp OFF
Lamp Replacement
Error Log
Error Count
PB Log 1
Information
Record the time of operation in the time of Lamp
Other
SEIKO EPSON
Clearing the Lamp Information
While the AS menu is displayed,
press and hold the [Source Search] and
[Up] buttons together
on the projector for 10 seconds.
N/A
Reset to 0
Reset to 1
Reset to 0
Add 1 to the current value
N/A
N/A
N/A
N/A
replacement.
(EB-FH52/992F, EH-TW750)
Appendix
Clearing the AS Information
While the AS menu is displayed,
press and hold the [Source Search] and [Down]
buttons together on the
projector for 10 seconds.
Reset to 0
Reset to 0
Reset to 1
Reset to 0
Reset to 0
N/A
N/A
N/A
N/A
Initializes the forced low brightness transfer times.
(to 0)
190
INTERNAL USE ONLY
Clearing the Log Information
While the AS menu is displayed,
press and hold the [Right] button on the
projector (or the remote controller) for 5 seconds or
more,
and press and hold the [Enter] button for 2 seconds
or more within
3 seconds after that.
N/A
N/A
N/A
N/A
N/A
Spacing
(Initialized to the status of acquiring none)
Reset to 0
Spacing
(Initialized to the status of acquiring none)
Delete
Initializes the warning count.
Revision A