Huawei iBattery 3.0 Quick Manual page 16

Open the mobile phone app and go to the homepage.
Select Stock to access the Stock page.
Click + in the upper right corner and choose Ibat Collection.
On the IBAT Scan page, click
Click Save in the upper right corner. The collected
information is saved in CSV format and stored in the
Locate the doc that stores iBAT SN and upload it to the
computer. Save sequence numbers of iBATs related to
the same iBOX a CSV file according to the battery
4. On the iBOX Web page, select System Settings > Parallel Net Join Config, and set Parallel
Net Join Status to Enable.
5. Perform iBAT SN number import to import the iBAT SN information to the corresponding iBOX.
•
Set Parallel Net Join Status to Enable for all iBOXs.
•
Ensure that the configured number of batteries is consistent with the number of scanned
batteries. Otherwise, the import fails.
Do not operate the networking switch during networking. Otherwise, the networking fails. You need to
clear the network parameters for the iBOX, set Parallel Net Join Status to Enable, and separately
press the networking switch for 2 seconds on the iBOX and on the iBAT for which the network
parameters have been cleared when the iBOX network parameters are cleared, to complete the
networking again.
6. Hold down all iBOXs networking switch for 2 seconds. The ALM indicator blinks red once, and
the RF_Z indicator turns from steady green to blinking green at super short intervals, which
indicates that the iBOX is being networked.
7. Hold down all iBATs networking switch for 2 seconds. When the RUN/ALM indicator turns from
steady red to blinking green at short intervals, and finally to blinking green at long intervals, the
iBAT connects to the iBOX network.
8. After all iBATs are successfully connected in the parallel network, when the RF_Z indicator on
the iBOX turns from blinking green at super short intervals to blinking green at long intervals, the
networking is complete.
to collect iBAT SN info.
BatteryApp path.
sequence numbers.
•
•
•
16
NOTE
You can manually enter SN
on the Service Expert app to
collect the iBAT SN
information.
Save the iBAT information file
in CSV format.
It is recommended that the
names of CSV files
correspond to different iBOXs.