Huawei iBattery 3.0 Quick Manual page 14

7. Access the System Settings page, and set the Time, IP Address, Battery Curve, and Parallel
Net Join Config parameters according to the following table.
System Settings
Time
IP Address
Battery Curve
Parallel Net Join Config
5.3
Logging In to the NetEco and Setting Parameters
1. Enter https://NetEco IP address in the address box of
Internet Explorer to log in to the NetEco homepage.
2. Access the Configuration > Data Center Planning page,
and select the site where the iBOX is located.
3. Choose Device > Battery Detector and drag the BMU
icon to the creation area.
4. On the Management Info pane, set the Name, IP
Address, Port, and Connection Mode for the iBOX.
5. Click Connection Test and save the setting after a
message indicating successful connection appears.
•
IP address: Must be the same as the iBOX IP address.
•
Port: Set to 502.
•
Connection mode: Must be consistent with the iBOX
setting.
•
When multiple iBOXs are connected in parallel, you
need to set parameters on the NetEco for each iBOX.
iBOX Parameters:
ModbusTCP encryption and
ModbusTCP authentication
Disable
Enable
6
Networking the iBOX and iBAT
Networking switch ALM indicator RF_Z indicator Networking switch RUN/ALM indicator
Description
Set the local time zone, date, and time.
Set the IP address, subnet mask, and default gateway of the iBOX. Set
this parameter based on the IP address assigned by the administrator.
Sets the battery curve based on the battery brand and format.
Sets this parameter when you connect iBOXs in parallel.
NetEco Parameter:
Connection Mode
Non-SSL Connection
SSL Connection
14
NetEco page