Huawei ACBox2000-21-D-A User Manual page 32

Table of Contents

ACBox2000-21-D-A

User Manual (Pan-Europe Edition)

Ensure that the jacket is in the waterproof connector.

Figure 5-6 Peeling a cable (three core wires)

(A) Core wire

Figure 5-7 Peeling a cable (four core wires)

Step 2 Insert each exposed core wire into the crimping area of an OT terminal and crimp them using

hydraulic pliers.

One core wire should be connected to one OT terminal.

Step 3 Wrap the wire crimping area with heat shrink tubing or PVC insulation tape.

If heat shrink tubing is used, put it over the cable and then crimp the OT terminal. Blow the heat shrink

tubing using a heat gun until the tubing closely wraps the wire crimping area of the OT terminal. When

using the heat gun, protect devices from being scorched.

Step 4 Remove the locking cap from the AC INPUT1 waterproof connector at the bottom of the

ACBox2000 and remove the plug from the locking cap.

Step 5 Route the AC input power cable into the locking cap and then the AC INPUT1 waterproof

connector.

Issue 01 (2016-12-15)

(B) Insulation layer

Huawei Proprietary and Confidential

5 Electrical Connections

Table of Contents