Siemens SINUMERIK 840D sl Series Diagnostics Manual page 486

Overview of Alarms
%2 = Block number, label channel number
Definitions: The alarm is triggerd by the following cycles: CYCLE971.
Parameter _TP[x,9] distance between upper edge and lower edge of tool probe equals 0;
relevant for radius measurement.
Remedy: Check parameter _TP[x,9].
61350
Channel %1 block %2: feed, speed not programmed in _MFS for tool measurement
with rotating spindle
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions: The alarm is triggerd by the following cycles: CYCLE971.
Measuring feed and/or spindle speed of tool measurement with rotating spindle in GUD
variable _MFS[2] not specified.
Remedy: Check parameter _MFS[2].
61351
Channel %1 Block %2: Tool length or radius is 0
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions: The alarm is triggerd by the following cycles: CYCLE971.
For the active tool, the length or radius equal zero.
Remedy: Check length and radius of the active tool in the compensation data memory.
61352
Channel %1 Block %2: Path for logfile not permitted
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions: The alarm is triggerd by the following cycles: CYCLE106.
The specified path for the log file is incorrect.
Remedy: Check parameter _PROTNAME[1].
61353
Channel %1 Block %2: Path for logfile not found
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions: The alarm is triggerd by the following cycles: CYCLE106.
The specified directory does not exist or the specified path is incorrect.
Remedy: Check parameter _PROTNAME[1].
61354
Channel %1 Block %2: File for logfile not found
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions: The alarm is triggerd by the following cycles: CYCLE106.
No name specified for the log file.
Remedy: Check parameter _PROTNAME[1].
61355
Channel %1 Block %2: Incorrect file type for logfile
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions: The alarm is triggerd by the following cycles: CYCLE106.
The file extension for the log file is incorrect.
Remedy: Check parameter _PROTNAME[1].
2-486
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
© Siemens AG, 2005. All rights reserved
08/2005