Siemens SINUMERIK 840D sl Series Diagnostics Manual page 364

Overview of Alarms
22065
Channel %1 tool management: Tool motion is not possible, as tool %2 with Duplo
no. %3 is not in magazine %4
Parameters: %1 = Channel number
%2 = String (identifier)
%3 = Duplo no.
%4 = Magazine no.
Definitions: The desired tool motion command - triggered from the MMC or PLC - is not possible. The
specified tool is not contained in the specified magazine. (NCK cannot contain tools that
are not assigned to a magazine. With this kind of tool, no operations (motion, change) can
be performed.)
Reactions: - NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Remedy: Check that the specified tool is contained in the desired magazine, or program another
tool to be changed.
Program Con- Clear alarm with the Delete key or NC START.
tinuation:
22066
Channel %1 tool management: Tool change is not possible, as tool %2 with Duplo
no. %3 is not in magazine %4
Parameters: %1 = Channel number
%2 = String (identifier)
%3 = Duplo no.
%4 = Magazine no.
Definitions: The desired tool change is not possible. The specified tool is not contained in the speci-
fied magazine. (NCK cannot contain tools that are not assigned to a magazine. With this
kind of tool, no operations (motion, change) can be performed.)
Reactions: - NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
Remedy: Please inform the authorized personnel/service department.
• Check that the specified tool is contained in the desired magazine, or program another
tool to be changed.
• Check whether the settings in machine data $MC_RESET_MODE_MASK,
$MC_START_MODE_MASK and the associated machine data
$MC_TOOL_RESET_NAME match the current definition data.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
22067
Channel %1 tool management: tool change not possible since there is no tool avail-
able in tool group %2
Parameters: %1 = Channel number
%2 = String (identifier)
Definitions: The desired tool change is not possible. The specified tool group does not contain a tool
which is ready for use and could be used for tool change. It is possible that all of the tools
in question have been set to the 'Disabled' state by the tool monitoring function.
Reactions: - NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm at block end.
2-364
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
© Siemens AG, 2005. All rights reserved
08/2005