Installing the Wired Controller
For Debris Blowers with Serial Numbers
310000001 to 311000001
1. Disconnect the battery cables from the battery.
Note: Disconnect the negative-battery cable first, and
then disconnect the positive-battery cable.
2. Disconnect the wire-harness leads from the
wireless-control base
3. Plug the appropriate wired-controller harness lead into
the appropriate wire-harness lead that was previously
disconnected from the wireless-control base
3
and
Figure
4).
1
g018907
1. Pink wire from the adapter
2. Wire-harness lead
to wireless-controller
harness
(Figure
1).
(Figure
2
3
Figure 3
3. Wire-harness lead to the
wire controller
1. Connect this wire-harness
lead to the wired-controller
harness.
2. Wireless-control base wire
harness
3. Wireless-control base
4. Connect this wire-harness
lead to the wire-harness
adapter.
4. Plug the appropriate lead from the harness adapter
into the remaining wireless-control base wire-harness
lead that was previously disconnected from the
wireless-control base
5. Plug the other wired-controller-harness lead into the
appropriate wire-harness-adapter lead
Figure
4).
6. Plug the remaining controller wire into the pink wire
from the harness adapter
7. Connect the positive-battery cable first, and then
connect the negative-battery cable.
3
Figure 4
5. Wire-harness adapter
6. Wired controller
7. Yellow wire from the
wired-controller harness
(Figure
3).
(Figure 3
(Figure 3
and
Figure
and
4).