is issued after power up or after a time out where all overridden points were released, as long as no Identify yourself command
has been issued by the master.
Error Code 01
is issued if the command is not supported or not known by the drive.
Error Code 02
is issued if the received message has a checksum error.
Error Code 03
is issued if the N2 message receive buffer exceeds 256 characters.
Error Code 05
is issued if the received N2 message is too long.
Error Code 10
is issued the data is out of expected range
Error Code 11
is issued when:
1. A point attributes or attribute bit is unused.
2. A point attributes or attribute bit is for JCI use only.
3. An internal data point attribute for current value can not be changed while running
Error Code 12
is issued when:
1. The N2 master tries to change attribute 2 bit 6 "Current State" on a BO and the drive is tripped.
2. The N2 master tries to change attribute 2 bit 6 "Current State" on a BO and the drive is trip locked except for BO 5 "reset"
2.1.5 Drive Parameters
The following parameters may need to be manually set for each drive in the Metasys N2 network. Refer to the Installation, Operation and Maintenance Manual