Johnson Controls Inc. developers of the METASYS N2 protocol
N2
METASYS N2
N2 master
A N2 master is either a PC with JCI software or a dedicated JCI controller
NAK
Not acknowledged
NPA
N2 Point Address (Each N2 Point Type has a address range from 0 to 255)
NPT
N2 Point Type
PAR
Parameter Number
2.1.2 Network Connection
Connect signal wires to terminal 68 (N+) and terminal 69 (N-) on main control board of the drive. If shielded cabling is used, connect one end of the shield to
terminal 61. This terminal is connected to ground via an internal RC link. It is highly recommended to use twisted-pair cables to reduce the differential mode