Table of Contents
Advertisement
Engine unit - drive shaft
Dismantling
Clamp the clearing in fixture No 502 5103-01.
Remove the cylinder casing and disconnect the
shortcircuiting cable from the stop contact.
Back off the four screws in the clutch housing.
Separate the engine unit from the drive shaft. This may
be facilitated by careful tapping with a plastic mallet.
Assembly
Assemble in reverse order to removal.
Lubricate the shad carrying the centrifugal clutch with
a few drops of oil and ht the engine unit to the clutch
housing.
Make sure that the carburettor controls are in the right
position, particularly the choke control,
Apply a few drops of Loctite to the screws and tighten the
engine to the clutch housing.
NOTE: ins extremely important to ensure that the four
screws are properly tightened .
Connect the short-circuiting cable to the stop contact.
Fit the cylinder casing in place.
Clutch housing - suspension tube
Dismantling
Clamp the clearing saw in fixture No 502 5103-01.
Separate the engine unit from the drive shaft.
Withdraw the clutch drum and drive shaft from the drive
shaft tube.
Remove split pin A.
Back off screws B and C at the rear vibration dampers
and also clamping screw D.
Pull the suspension tube rearward and back off the two
clamping screws E and stop screw F.
Withdraw the clutch housing and suspension tube from
the drive shaft tube.
10:1
Hide quick links:
Advertisement
Table of Contents
