Control Panel - GRAPHTEC CUTTING PRO FC2250 Series User Manual

1.5 Control Panel

POWER Lamp PROMPT Lamp F1 to F4 Key POSITION Key COPY Key CONDITIOS Key NEXT Key PAUSE Key ENTER Key TEST Key ORIGIN Key
Indicator Lamps
................The POWER lamp remains lit (green) while the plotter is on.
..............The PROMPT lamp lights (red) when the plotter receives data that will cause the pen carriage
(ES [electrostatic adhesion] models only)
......................Press the [CHART HOLD] key to enable the electrostatic adhesion function (the key's lamp
Panel Keys
......................Depending on the setting screen being displayed, these keys are used to:
..............Depending on the plotter's operating status, these keys are used to:
...........................Used to output a copy of the data in the plotter's receive buffer.
.........................Used to change the currently displayed cutting conditions.
...........................Used to select the desired menu screen for setting a function at the control panel when the
...........................Press the [PAUSE] key to select PAUSE mode (its green lamp lights).
to move outside the effective cutting area or receives the Prompt Light command (T) from the
computer.
lights). Press it again to cancel the electrostatic adhesion function (the lamp goes off).
•
Load a group of cutting conditions retained in the plotter's memory;
•
Shift the blinking display in a conditions setting screen;
•
Select the desired submenu in a menu screen.
•
Move the pen carriage;
•
Move the blinking display in a conditions setting screen; ([
•
Raise or lower the numeric value of a setting; ([
•
Change the pen type. ([
•
Press the [ ] key and the [ENTER] key concurrently to move the pen carriage to the upper
right position. To move the pen carriage to the origin position, press the [
[ENTER] key concurrently.
plotter is in PAUSE mode.
Press it again to cancel PAUSE mode (the lamp goes off).
Depending on the plotter's operating status, this key is used to:
•
Temporarily suspend a cutting or plotting operation.
•
Set functions at the control panel.
•
Temporarily store data received from the computer in the plotter's buffer.
] and [
] and [ ] keys)
Chapter 1 PRODUCT SUMMARY
] and [ ] keys)
] keys)
] key and the
1-5