5D Coaxial Cable - NEC iPasolink 200 Manual

CABLE TERMINATION

6.1 5D Coaxial Cable

Procedure 6-1
Outlines of parts
Cable jacket
Braided wire
Insulator
Tools
1 Insertion of parts, remove of jacket of cable.
(1) The clamp nut is inserted as shown.
(2)
Note
Installation
Submission Prohibited
NEC Internal Use Only
TNC-P Connector used for IDU IF IN/OUT
(L-angle:TNC150(R0))
[Applicable cable: 5D-FB-E]
Aluminum tape
Center conductor
• knife, cutter, nipper, tweezers, file, measure,
clearance gauge, etc.
• spanner, torque spanner 14 mm
Remove 8 mm of jacket only.
Cable
(8 mm)
Clamp nut
Do not damage the braided wire.
Clamp
Connector body
*Cut the jacket edge squarely.
6-3
Clamp nut
NWD-107460-02E