Odu Direct Mounting Type Antenna - NEC iPasolink 200 Manual

ODU MOUNTING
3 Holding the feed with hand, rotate the feed 90 degrees,
Check that the aperture part of the Transition hub is rotated 90 degrees, then fix it
with the screws that were loosened in step 2,
4 Check that the aperture part of the Transition hub is rotated 90 degrees, then fix it
with the screws that were loosened in step 2
Note
(2)) ODU Direct Mounting Type Antenna (ANDREW example #2)
Notes
1 Keep the antenna stand horizontally,
2 Loosen six screws with Allen wrench until transition can rotate freely,
Notes
Installation
Submission Prohibited
NEC Internal Use Only
Top
Polarization
V
When a large and a small gasket are included in the antenna package.
Please use the large one. (The small gasket is not used in antenna
mount.)
1. The details are referred to the installation manual which is attached to
the antenna. The installation or removal of the antenna requires qualified
experienced personnel.
2. The antenna is set to V-polarization when shipped from the factory.
1. Do not remove the screw complete from the screw hole.
2. Because of the screwtight is applied, the strength to loosen screw is
necessary.
Top
Polarization
H
5-13
NWD-107460-02E