Advertisement
8. ASSEMBLY
8.1.
ASSEMBLE THE REAR WALL PANELS
8.1.1.
You will find it easier to assemble the shed using trestles with timber studding of equal or greater panel length. Trestles can be supplied
separately by your Jack Sealey dealership. Attach the studding to trestles with equal overhang using nylon cable ties or similar "safe"
method.
8.1.2.
Place panel 1A and 1L on your work table and join them together with the 10mm long self tapping screws.
See the pre-punched holes and both diagrams.
8.1.3.
Fit top and bottom channels 20B and 20C to panels by firstly sliding and finally tapping into place as indicated by arrows in the diagrams.
Note that the smaller flange on the channels should always be adjacent to the out side face of the panel; this prevents rainwater entering
the compartment of the shed. The outside face is the top face in both diagrams.
© Jack Sealey Limited
Original Language Version
GSS150819SDG Issue: 1 - 27/08/14
Advertisement
