Table of Contents
Advertisement
Selecting and changing pre-programmed
recipes
Example in the diagram: Setting for aubergine gratin, 0.7 kg =
Programme 2.
Use the function selector to select the function for the pre-
1.
programmed recipe
.
X
The first programme appears on the display panel.
Using
@
or
A
, select the desired programme number.
2.
Pre-programmed recipe tips
The weight of the joint or poultry is
greater than the weight range specified.
Care and cleaning
If cleaned and properly cared for, your oven will keep its bright
appearance and operating performance for many years to
come. Advice on how to care for and clean your oven is
provided below.
Notes
Different colours may be seen in your front panel due to the
■
various materials used in its manufacture, such as glass,
plastic and metal.
Dark patches in the door's glass panel may seem to be dirt
■
but they are in fact reflections from the oven light.
Enamel burns at very high temperatures. This may cause
■
slight discolouration. This is normal and does not affect the
oven's operation. The edges of thin baking trays may not be
completely enamelled. They may therefore feel slightly rough,
although their corrosive protection will be unaffected.
Cleaning products
Follow the indications provided in the table to avoid damaging
the various oven surfaces by using unsuitable cleaning
products. Do not use
abrasive or acidic cleaning products
■
strong products containing alcohol
■
scourers or hard sponges,
■
high-pressure or steam cleaners
■
The weight range is deliberately limited. For very large joints, it is often impossible to
obtain a sufficiently large roasting dish. Use top/bottom heating
ing
4
to cook large joints, etc.
Touch the sensor button
3.
using
or
.
@
A
The programme will start after a few seconds. You will see the
cooking time counting down on the display panel and the
symbol will be lit.
The program has now finished
The oven will beep. The oven will stop heating. The display
panel will show
:
. The signal can be switched off in
‹‹
‹‹
advance with the
sensor.
0
Changing the program
After starting, you cannot change either the program number or
the weight.
To cancel the program
Set the function control knob to the zero setting. The oven
switches off.
Changing the cooking time and end time
With preset recipes you cannot change the cooking time or end
time.
Wash new dishcloths thoroughly before use.
Zone
Cleaning products
Front panel
Hot water and a little soap:
Clean with a dishcloth and dry with a
soft cloth. Do not use a glass cleaning
product or a glass scraper.
Stainless steel
Hot water and a little soap:
Clean with a dishcloth and dry with a
soft cloth. Immediately remove any
water marks, grease, cornflower or egg
white stains since corrosion could
occur underneath these marks or
stains.
Special products for the care of stain-
less steel and which are suitable for
hot surfaces may be obtained from
Technical Assistance Service centres
and specialist retail outlets. Use a very
fine soft cloth to apply the cleaning
product.
Glass panel
Glass cleaning products:
Clean using a soft cloth. Do not use a
glass scraper.
and set the weight of the food
‚
or circulated air grill-
%
x
11
Advertisement
Table of Contents
