Advertisement
Quick Links
Ultra Sonic Boom
2013 and After Multi Pro
Model No. 130-8229
Note: The Ultra Sonic Boom Leveling Kit (Toro part number 41219) is required to install this kit.
Note: Determine the left and right sides of the machine from the normal operating position.
This product contains a chemical or chemicals known to the State of California to
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
© 2015—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
Proposition 65 Warning
cause cancer, birth defects, or reproductive harm.
Description
Valve-mount bracket
Hydraulic manifold block (ordered
separately)
Hydraulic fitting (ordered separately)
Mounting bracket
Wiring harness
Electronic controller (ordered
separately)
Bolt (1/4 x 1-1/8 inch) (ordered
separately)
Locknut (1/4 inch) (ordered separately)
Register at www.Toro.com.
™
Finishing Kit
®
5800 Turf Sprayer
WARNING
CALIFORNIA
Qty.
1
1
4
1
1
1
4
4
Form No. 3396-881 Rev A
Installation Instructions
Use
Install the valve-mount bracket.
Mount the electronic controller.
Original Instructions (EN)
All Rights Reserved *3396-881* A
Printed in the USA
Advertisement
Related Manuals for Toro Ultra Sonic Boom 130-8229
Summary of Contents for Toro Ultra Sonic Boom 130-8229
- Page 1 5800 Turf Sprayer Model No. 130-8229 Installation Instructions Note: The Ultra Sonic Boom Leveling Kit (Toro part number 41219) is required to install this kit. Note: Determine the left and right sides of the machine from the normal operating position. WARNING...
- Page 2 3. Loosen the 2 hydraulic connectors on the right side and the gauge port on the left side of the hydraulic manifold block (Figure Installing the Valve-Mount Bracket Parts needed for this procedure: Valve-mount bracket Hydraulic manifold block (ordered separately) Hydraulic fitting (ordered separately) Procedure Note: You can find the hydraulic manifold block and...
- Page 3 7. Install the valve-mount bracket using the 2 bolts (5/16 10. Install the new hydraulic manifold block onto the x 1 inch) and 2 locknuts (5/16 inch) that you previously valve-mount bracket with the 2 bolts (5/16 x 3 inch) removed (Figure and 2 locknuts (5/16 inch) that you previously removed...
- Page 4 2. Remove the 2 bolts and install the mounting bracket to the machine seat frame (Figure Mounting the Electronic Controller Parts needed for this procedure: Mounting bracket Wiring harness Electronic controller (ordered separately) Bolt (1/4 x 1-1/8 inch) (ordered separately) Locknut (1/4 inch) (ordered separately) Procedure Figure 7...
- Page 5 5. Connect the terminal of the wiring harness into the electronic controller (Figure Note: The controller connection is keyed and can be connected in only 1 way. Figure 9 1. Electronic controller 2. Wiring harness terminal 6. Route the wiring harness to the hydraulic manifold. Figure 10 7.
- Page 6 Notes:...
- Page 7 Notes:...