Preparing the Machine Disconnecting the Battery No Parts Required No Parts Required Procedure Procedure 1. Park the machine on a level surface. WARNING 2. Engage the parking brake. Incorrect battery cable routing could damage 3. Shut off the engine and remove the key. the sprayer and cables causing sparks.
Page 3
Routing the Wire Harness Parts needed for this procedure: Wire harness g024082 Figure 2 Preparing to Route the Wire 1. Nut 3. Terminal (positive-battery Harness cable) 2. Battery post 4. Bolt Use the following graphic as an outline of routing the wire harness to the machine (Figure g209688...
Page 4
Routing the Wire Harness to the Front of the Machine Route the wire harness from the rear of the machine to the console as shown in Figure g208589 Figure 4 1. Wire harness Installing the Switches 1. Route the 8-socket connectors through the console (Figure 2.
Page 5
Installing the Wire Harness to the Fuse Block 1. Route the wire harness under the seat (Figure g210250 Figure 8 1. Connector—ultra sonic 2. Connector—machine boom finishing kit g210299 Figure 6 Installing the Wire Harness to the 1. Wire harness 2.
Page 6
Installing the Wire Harness to the Battery 1. Route the harness to the left from the side console to the flasher module. 2. Route the harness leg with the ring terminal to the positive post of the battery (Figure 10). g036958 Figure 10 g208941...
5. Install the electronic controller cover; refer to the Installation Instructions for the ultra sonic boom leveling kit. Connecting the Battery No Parts Required Procedure 1. Align the ring terminal for the machine wire harness, the ring terminal of the kit wire harness, and the terminal for the positive battery cable to the positive battery post (Figure...