Replacing The Fuel Filter; Servicing The Fuse; Headlights - Toro Wheel Horse 13-32XLE Operator's Manual

Replacing the Fuel Filter

Replace the fuel filter after every 100 operating hours or
yearly, whichever occurs first.
The best time to replace the fuel filter (Fig. 29) is when the
fuel tank is empty. Never install a dirty filter if it is
removed from the fuel line.
1. Disengage the PTO, shift into neutral, set the parking
brake, stop the engine, and remove the ignition key.
2. Open the hood.
3. Squeeze the ends of the hose clamps together and slide
them away from the filter (Fig. 29).
4. Remove the filter from the fuel lines.
5. Install a new filter and move the hose clamps close to
the filter.
6. Close the hood.

Servicing the Fuse

The electrical system is protected by fuses. No maintenance
is required, however, if a fuse blows, check the circuit
wiring for a short. To replace a fuse, pull up (Fig. 30) to
remove it from the socket. Push down to insert it.
Fuses: 10 amp, blade-type
Figure 30
1. Fuse (removed)

Headlights

Specification: Bulb #1156, automotive type
Removing the Bulb
1. Disengage the PTO, shift into neutral, set the parking
brake, stop the engine, and remove the ignition key.
2. Open the hood. Pull the wire connectors off of both of
the bulb holder terminals.
1
2
m–1672
2. Socket
27
3. Rotate the bulb holder 1/4 turn counterclockwise and
remove it from the reflector (Fig. 31).
4. Push and rotate the bulb counterclockwise until it stops
(approx. 1/4 turn) and remove the bulb from the bulb
holder (Fig. 32).
5
3
2
4
Figure 31
1. Bulb holder
2. Reflector
3. Tabs
Installing the Bulb
1. The bulb has metal pins on the side of its base. Align
the pins with the slots in the bulb holder and insert the
base into the holder (Fig. 32). Push and rotate the bulb
clockwise until it stops.
2
4
3
Figure 32
1. Bulb
2. Metal pins
2. The bulb holder has two tabs (Fig. 31). Align the tabs
with the slots in the reflector, insert the bulb holder into
the reflector, and rotate it 1/4 turn clockwise until it
stops.
3. Push the wire connectors onto the terminals on the bulb
holder.
5
1
4
m–1874
4. Slots
5. Terminals
1
2
4
m–1875
3. Bulb holder
4. Slots