Table of Contents
Advertisement
6
Install the Front Tubes and the
Hydraulic Hose
Parts needed for this procedure:
1
Hydraulic tube, part no. 108-7622
1
Hydraulic tube, part no. 108-7623
1
Hydraulic fitting, 90 degrees
1
Hydraulic hose
3
Cable tie
Procedure
1. Connect hydraulic tube, part no. 108-7622, to the right
wheel motor fitting and to the right hydraulic tube in
the right frame bulkhead (Figure 11).
1. Right wheel motor
2. Right frame bulkhead
3. Hydraulic tube, part no.
108-7622
4. Left wheel motor
5. Hydraulic tube, part no.
108-7623
6. Left frame bulkhead
2. Connect hydraulic tube, part no. 108-7623, to the left
wheel motor fitting and to the left hydraulic tube in the
right frame bulkhead (Figure 11).
3. Install a 90 degree hydraulic fitting into the bottom of
the variable pump (Figure 11).
4. Connect the hydraulic hose to the left hand pump
fitting and to the hydraulic tube at left frame bulkhead.
If the right hand hose was removed, connect it at this
time.
5. Secure the hydraulic hose to the bottom of the battery
tray with a cable tie (Figure 11).
6. Install the wheel shields to the front axle flanges with
the cap screws and nuts previously removed (Figure
10).
7. Install the cable ties to secure the brake cables to the
hydraulic tubes.
Figure 11
7. Variable pump
8. 90 degree fitting
9. Hydraulic hose
8
10. Battery tray
11. Cable tie
Advertisement
Table of Contents
