No Parts Required - Toro 03655 Installation Instructions Manual

5
Remove the Front Tube and
the Hydraulic Hose

No Parts Required

Procedure
1. Raise the front of the unit and support it on jack stands.
1. Wheel shields
2. Hydraulic tube
6. Disconnect the left hand hose from the variable pump
and the hydraulic tube (Figure 10). Also, remove the 45
degree fitting from the bottom of the variable pump
(Figure 10).
Note: The right hand hose can also be removed to
improve clearance for the removal and installation of
the front tube. This is not necessary but can aid in the
installation of this kit.
2. Remove the lug nuts securing the wheel assemblies and
3. Remove the cap screws and nuts securing the wheel
4. Disconnect the hydraulic tube from the top fitting on
5. Remove the R-clamps securing the tube to the frame
Figure 10
3. Screw
4. Hose connection fitting
7
remove the wheels.
shields to the front axle flanges (Figure 10).
the front left wheel motor and the bottom fitting on
the front right wheel motor (Figure 10).
(Figure 10) and the cable ties securing the brake cables
to the hydraulic tubes.
5. Lock nut
6. R-clamp