Toro FP Series Operator's Manual page 4

– Never refuel or drain the machine indoors.
•
Ensure that the shields are attached and functioning
properly.
Operation
•
Never run an engine in an enclosed area.
•
Only operate in good light, keeping away from holes and
hidden hazards.
•
Do not operate in standing water.
•
Slow down and use caution when making turns.
•
Stop on level ground, set the throttle to slow, and shut
off the engine before leaving the operator's position for
any reason.
•
Ensure that the area is clear of other people before
operating the machine. Stop the machine if anyone enters
the area.
•
Keep pets and bystanders away.
•
Keep feet clear of the plate compactor.
•
Ear protection is required when operating this equipment.
•
Do not operate the machine under the influence of
alcohol or drugs.
•
For foot protection, wear steel toe shoes or toe pads.
•
Never operate with the guards not securely in place.
•
Do not change the engine governor setting or overspeed
the engine.
•
Use care when loading or unloading the machine into a
trailer or truck.
•
Never leave the machine running unattended. Always
set the throttle to slow, stop the engine, and wait for all
moving parts to stop before leaving.
•
Do not touch parts which may be hot from operation.
Allow them to cool before attempting to maintain, adjust,
or service.
•
Before compacting soil, have the area marked for
underground utilities.
•
Lightning can cause severe injury or death. If lightning
is seen or thunder is heard in the area, do not operate
the machine; seek shelter.
Maintenance and Storage
•
Park the machine on a level surface, set the throttle to
slow, and stop the engine. Wait for all movement to stop
before adjusting, cleaning, or repairing.
•
Clean debris from the drives, mufflers, and engine to help
prevent fires. Clean up fuel and oil spillage.
•
Let the engine cool before storing and do not store near
flame.
•
Do not store fuel near flames or drain indoors.
•
Park the machine on level ground. Never allow untrained
personnel to service the machine.
•
Carefully release pressure from components with stored
energy.
•
Disconnect the spark plug before making any repairs.
•
Keep hands and feet away from moving parts. If possible,
do not make adjustments with the engine running.
•
Keep all parts in good working condition and all hardware
tightened. Replace all worn or damaged decals.
•
Keep nuts and bolts tight. Keep equipment in good
condition.
•
Keep the machine free from the build-up of mud, rocks,
or other debris. Clean up oil or fuel spillage. Allow the
machine to cool before storing.
•
Use extra care when handling fuels. They are flammable
and vapors are explosive.
– Use only an approved container.
– Never remove the fuel cap or add fuel when the
engine is running. Allow the engine to cool before
refueling. Do not smoke.
– Never refuel the machine indoors.
– Never store the machine or fuel container inside
where there is an open flame, such as near a water
heater or furnace.
– Never fill a fuel container while it is inside a vehicle,
trunk, pick-up bed, or any surface other than the
ground.
– Keep container nozzle in contact with the tank during
filling.
•
Stop and inspect the equipment if you strike an object.
Make any necessary repairs before restarting.
•
Use only genuine Toro replacement parts to ensure that
original standards are maintained.
4