Operating The Compactor; Transporting The Machine - Toro FP Series Operator's Manual

Forward plate compactor
Table of Contents

Advertisement

Figure 14
1. Choke
4. Move the throttle lever midway between slow (turtle)
and fast (rabbit) positions (Figure 15).
Note: A warm or hot engine may not require choking.
Figure 15
1. Throttle
5. Pull the recoil handle sharply to start the engine.
6. After the engine starts, gradually move the choke to the
right. If the engine stalls or hesitates, move the choke
left again until the engine warms up.
7. Move the throttle lever to maximum throttle.
1
g019774
1
g019775
11
Stopping the Engine
1. Move the throttle lever to the slow (turtle) position.
2. Turn the engine switch and fuel valve off.

Operating the Compactor

With the engine at full throttle, the compactor will move
forward while vibrating.
Grasp the handle lightly with both hands and allow the
compactor to move forward on its own. Use the handle to
guide the direction of travel to avoid obstructions.

Transporting the Machine

Model 68025 weighs 64 kg (140 lb)
Model 68026 weighs 93 kg (205 lb)
Model 68027 weighs 98 kg (215 lb)
The rollcage lifteye can be used to lift and transport the
machine with straps or a crane (Figure 16).
Alternatively, 2 people can transport the machine by lifting the
compactor using the front and rear lift handles (Figure 16).
Figure 16
1. Rollcage lifteye
1
g019776
2
2. Lift handles

Advertisement

Table of Contents
loading

This manual is also suitable for:

680256802668027

Table of Contents