Storage - Toro FP Series Operator's Manual

9. Apply medium-grade thread-locking compound to the
threads of the flanged-head bolts that you removed in
step 1 of Removing the Belt Cover (page 16).
10. Align the belt cover to the machine and secure the
cover with the flanged-head bolts that you removed in
step 1 of Removing the Belt Cover (page 16).
11. Torque the bolts to 972 to 1198 N-cm (86 to 106 in-lb).

Storage

1. Stop the engine, and disconnect the spark-plug wire.
2. Remove dirt and grime from the entire machine.
Important: You can wash the machine with mild
detergent and water. Do not pressure wash the
machine. Avoid excessive use of water, especially
near the engine.
3. Service the air cleaner; refer to Servicing the Air
Cleaner (page 13).
4. Change the engine oil; refer to Changing the Engine
Oil (page 15).
5. For storage over 30 days, prepare the unit as follows:
A. Add a petroleum-based fuel stabilizer/conditioner
to fuel in the tank. Follow mixing instructions
from stabilizer manufacturer (1 oz per gallon). Do
not use an alcohol based stabilizer (ethanol
or methanol).
Note: A fuel stabilizer/conditioner is most
effective when mixed with fresh gasoline and used
at all times.
B. Run the engine until it stops from running out
of fuel.
C. Choke the engine.
D. Start and run the engine until it will not start again.
E. Dispose of fuel properly. Recycle as per local
codes.
Important: Do not store stabilizer/conditioned
gasoline over 90 days.
6. Check and tighten all bolts, nuts, and screws. Repair or
replace any part that is damaged.
7. Paint all scratched or bare metal surfaces. Paint is
available from your Authorized Service Dealer.
8. Store the machine in a clean, dry garage or storage area.
9. Cover the machine to protect it and keep it clean.
18