Table of Contents
Advertisement
5. Install the locking pin to secure the lever (Figure 5).
6. Cross or "X" the safety chains and attach them to the
holes on the hitch.
7. Plug tail light wire harness connector to the tow
vehicle connector. Check to make sure the brake lights
illuminate properly with the brake pedal applied and
the taillights flash when the turning signals are use.
8. Raise jack stand so caster wheels are free of the ground,
pull the release pin and rotate wheels rearward and lock
in the horizontal position (Figure 6).
1. Release pin
Tires and Wheels
The most common cause of tire trouble is under-inflation. It
is important that you maintain full air pressure.
Inflate main axle tires to 60 psi (410 kpa)
Check the torque of the wheel lug nuts initially and after the
first 10 hours of operation.
Torque wheel lug nuts to 80-90 ft.-lbs (108-122 Nm)
Before you Start
•
Review all the machine's safety decals.
•
Use a hard-hat, hearing protection, tight fitting gloves
without draw strings or loose cuffs, and eye protection.
A mesh visor alone does not provide sufficient eye
protection; supplement with protective glasses.
•
Ensure that you are familiar with safety regulations and
shutdown procedures described in this unit's Operator's
Manual and Engine Owner's Manual.
•
Ensure that all guards are in place and in good condition.
•
Ensure that the blades are in place and in good condition.
•
Ensure that the work areas and blades are free from
metallic objects such as wire, nails, etc. that could be
thrown out and injure persons in the vicinity and damage
the equipment.
Figure 6
2. Jack stand
•
Ensure that everyone, including children and animals,
maintain a distance of at least 50 feet (15 m) from the
machine. Debris can be thrown out and injure people
and animals.
•
Disconnect the unit from the tow vehicle, position it on
a level location and block the wheels front and back to
prevent it from moving.
•
Check the fuel and oil level of the engine.
G016605
10
Advertisement
Table of Contents
