Troubleshooting - Whirlpool W11 CM145 Instructions For Use Manual

TROUBLESHOOTING

Below is a list of some of the possible malfunctions.
If the problem cannot be resolved as described, contact Customer Services.
PROBLEM
The coffee is not hot.
The coffee is weak or not creamy
enough.
The coffee is delivered too slowly or a
drop at a time.
Coffee does not come out of one or
both of the spouts.
The appliance will not make coffee
The appliance does not come on
The infuser cannot be extracted
At the end of descaling, the appliance
requests a third rinse
The milk does not come out of the
milk spout (D5)
POSSIBLE CAUSE
The cups were not preheated.
The infuser has cooled down because
2/3 minutes have elapsed since the
last coffee was made.
A low coffee temperature is set.
The coffee is ground too coarsely.
The coffee is unsuitable.
The coffee is ground too finely.
The coffee spouts (A13) are blocked.
The appliance has detected impurities
in its internal circuits. "CLEANING UN-
DERWAY" is displayed.
It is not plugged into the mains socket. Plug into the mains socket (fig. 1).
The main switch (A19) is not turned
on.
The appliance has not been turned off
correctly
During the two rinse cycles, the water
tank (A12) has not been filled to the
MAX level
The lid (D2) of the milk container (D)
is dirty
32
REMEDY
Warm the cups by rinsing them with hot
water (Please note! you can use the hot water
function).
Before making the coffee, heat the infuser by
rinsing using the rinse function (see section
"Rinsing ").
Set a hotter coffee temperature in the menu (sec-
tion "Coffee temperature
Turn the grinding adjustment dial (A17) one
click anticlockwise towards "1" while the coffee
mill is in operation (fig. 11). Continue one click
at a time until coffee delivery is satisfactory. The
effect is only visible after delivering 2 coffees
(see section "Adjusting the coffee mill").
Use coffee for espresso machines.
Turn the grinding adjustment dial (A17) one
click clockwise towards "7" while the coffee mill
is in operation (fig. 11). Continue one click at a
time until coffee delivery is satisfactory. The ef-
fect is only visible after delivering 2 coffees (see
section "Adjusting the coffee mill").
Clean the spouts (fig. 31).
Wait for the appliance to be ready for use again
and reselect the required beverage. Contact
Customer Services if the problem persists.
Press the main switch (fig. 2).
Turn the appliance off by pressing the
(A7) (see section "Turning the appliance off").
Follow the instructions displayed by the appli-
ance, but first empty the drip tray (A14) to avoid
the water overflowing.
Clean the milk container lid as described in sec-
tion "Cleaning the milk container".
").
button