Huawei RTN 380H Quick Installation Manual page 7

Terminating an Outdoor Network Cable with Shielded RJ45 Connectors
Prepare an outdoor network cable
Prepare the following tools.
and shielded RJ45 connectors.
RJ45 connector crimping tool
1. Core wire
2. Aluminum foil
3. Braid shield
4. Outer jacket
5. Shielded RJ45 connector
Diagonal pliers
Insert the arranged core wires into an RJ45 connector according to the pin
assignments and crimp the connector with the crimping tool.
Crimp the RJ45
connector.
Pin assignments of an RJ45 connector
•Before crimping, ensure that the core wires are fully inserted in the RJ45
connector.
•Use the crimping tool to crimp the connector with force.
•After crimping, verify that the connector has been crimped tightly.
Preparing an RSSI Test Cable
Terminate one end of an outdoor network cable with an RJ45 connector
by following instructions in "Terminating an Outdoor Network Cable with
Shielded RJ45 Connectors."
Strip the other end of the cable, remain the core wire for pin 4 (blue) and
that for pin 7 (white and brown), cut off the other core wires, and wrap
this end.
12/13 >>
Strip the cable.
Length of the stripped
cable: 20 mm
When stripping off the outer jacket, take care not to damage the braid shield
or aluminum foil.
Cut off the exposed braid shield and materials
along the edge of the connector.
Cut off the exposed braid
shield and materials.
White and brown
core wire
Blue core wire
Strip off the braid shield and cut
Remove the outer jacket.
the aluminum foil and unwanted
materials.
Terminate a connector on the other end of the network cable, and then test the cable
for continuity using a network cable tester.
In addition to Ethernet services, the P&E port of the RTN 380H receives P&E signals from power
sourcing equipment. An outdoor straight-through cable is used to connect the P&E port and power
sourcing equipment.
The pin assignments of the P&E port on some Ethernet power supply equipment may be different
from those on the RTN 380H. In this case, you need to make a network cable based on the pin
assignments of the two P&E ports.
Pin assignments of the P&E port on the RTN 380H
Pin No.
1
BIDA+/BGND
2
BIDA-/BGND
3
BIDB+/-48V
4
BIDC+/BGND
5
BIDC-/BGND
6
BIDB-/-48V
7
BIDD+/-48V
8
BIDD-/-48V
Arrange the core wires according to the pin assignments and cut them
neatly (exposing a length of 12 mm).
Length of each exposed core wire: 12 mm
12 mm
Cut the core wires neatly.
8 Optional: Use a multimeter to measure the
impedance of core wires. The impedance
Outdoor network cable
difference between core wires must be less
than 5%.
Signal Function
Bidirectional data wire A (+)/Power ground
Bidirectional data wire A (-)/Power ground
Bidirectional data wire B (+)/-48 V power signal
Bidirectional data wire C (+)/Power ground
Bidirectional data wire C (-)/Power ground
Bidirectional data wire B (-)/-48 V power signal
Bidirectional data wire D (+)/-48 V power signal
Bidirectional data wire D (-)/-48 V power signal
8: brown
7: white and brown
6: green
5: white and blue
4: blue
3: white and green
2: orange
1: white and orange