Huawei RTN 380H Quick Installation Manual page 23

Installation Reference
Mapping Between the RTN 380H and the PIs
PI-DC B10
Device Type Version
PI Support
(Yes/No)
MXUI5 board No
RTN 380H
MXXI5 board No
Connection between PI and RTN 380H
When the RTN 380H is installed at a high position on a tower,
maintenance personnel cannot performance off-tower
RTN 380H
maintenance through WLAN. It is recommended to add an
outdoor network cable to connect the P&E2 interface of the PI.
The network element can be accessed by linking the notebook to
the GE2 interface for maintenance.
Connect to P&E Interface
Connect to COMBO(e)
A network management cable can be connected to the COMBO(e)
interface
port. In this case, you need to configure the COMBO(e) port as
an NMS port, or configure the network adapter of the laptop so
that the laptop can receive and transmit IP packets carrying DCN
VLAN IDs.
Network management cable
GE1 P&E1
Access GE
service
44/45 >>
PI-DC A10
PI Support
Power Supply Mode Power Supply Mode
(Yes/No)
N/A No
N/A No
NOTE
When a PI is used for P&E power supply for RTN 380H,
GE2 P&E2
the correct DIP switch:
Web LCT
PI-DC A11
PI Support
Power Supply Mode
(Yes/No)
N/A No N/A
N/A No N/A
CAUTION
• Turn DIP switch 1
for setting the
power output mode
downwards (P&E
OUT mode).
• Turn DIP switch 2
for setting the
number of P&E
outputs upwards
(P&E1 OUT mode).
PI-AC/DC B20
PI Support
Power Supply Mode
(Yes/No)
1. P&E1 port power supply (turn the DIP switch to the P&E1
Out Only)
Yes
2. Forcible power supply (turn the DIP switch to the Force
mode)
1. P&E1 port power supply (turn the DIP switch to the P&E1
Out Only)
Yes
2. Forcible power supply (turn the DIP switch to the Force
mode)