Lifting The Machine; Adjusting The Thigh Support - Toro 320-D Operator's Manual

Figure 19
1. Tie-down loops
Unloading the Machine
1. Lower the ramp (Figure
2. Unload the machine from the trailer with the
heavy end up the ramp, carrying loads low
(Figure 20).
•
If the machine has a full load-carrying
attachment (e.g., bucket or adjustable forks)
or a non-load-carrying attachment (e.g.,
stump grinder), back it down the ramp.
•
If the machine has an empty load-carrying
attachment or no attachment, drive it forward
down the ramp.
Figure 20
1. Machine with full
attachment or
non-load-carrying
attachment—back the
machine down the ramp.
g031331
17).
g204458
2. Machine with empty or
no attachment—drive the
machine forward down the
ramp.

Lifting the Machine

You can lift the machine using the tie-down/lift loops
as lift points; refer to
Adjusting the Thigh
Support
To adjust the thigh support
the knobs and raise or lower the support pad to
the desired height. You can also obtain additional
adjustment by loosening the nut securing the pad to
the adjustment plate, moving the plate up or down as
needed. Tighten all fasteners securely when finished.
1. Thigh-support bracket
2. Adjustment plate
3. Thigh-support pad
26
Figure 19.
(Figure 21), loosen
Figure 21
4. Knob and flat washer
5. Carriage bolt
6. Locknut and flat washer
g006054