Toro 320-D Operator's Manual page 15

Key Switch
The key switch, used to start and shut off the engine,
has 3 positions: O , R
FF
Starting the Engine (page
Throttle Lever
Move the control forward to increase the engine speed
and rearward to decrease speed.
Traction-Control Levers
•
To move forward, move the traction-control levers
forward.
•
To move rearward, move the traction-control levers
rearward.
•
To turn, move the lever located on the side you
want to turn back toward the N
while keeping the other lever engaged.
Note:
The farther you move the traction-control
levers in either direction, the faster the machine
moves in that direction.
•
To slow or stop, move the traction-control levers
to the N position.
EUTRAL
Attachment-Tilt Lever
•
To tilt the attachment forward, slowly push the
attachment-tilt lever forward.
•
To tilt the attachment rearward, slowly pull the
attachment-tilt lever rearward.
Loader-Arm Lever
•
To lower the loader arms, slowly push the
loader-arm lever forward.
•
To raise the loader arms, slowly pull the loader-arm
lever rearward.
Loader-Valve Lock
The loader-valve lock secures the loader-arm and
attachment-tilt levers so that you cannot push them
forward. This helps to ensure that no one accidentally
lowers the loader arms during maintenance. Secure
the loader arms with the lock anytime you need to
shut off the machine with the loader arms raised.
To set the lock, pull it back and all the way down
against the levers (Figure
Note:
You must move the levers rearward to engage
or disengage the loader-valve lock.
, and S . Refer to
UN TART
21).
position
EUTRAL
8).
1. Loader-valve lock
(engaged)
Auxiliary-Hydraulics Lever
•
To operate a hydraulic attachment in forward
direction, slowly pull the auxiliary-hydraulics lever
upward and then rearward.
•
To operate a hydraulic attachment in reverse
direction, slowly pull the auxiliary-hydraulics lever
upward and then push it forward. This is also
called the D
ETENT
require operator presence.
Speed-Selector Lever
•
To set the traction drive, loader arms, and
attachment tilt to high speed and the auxiliary
hydraulics to low speed, move the speed-selector
lever to the F
ORWARD
•
To set the auxiliary hydraulics to high speed and
the traction drive, loader arms, and attachment tilt
to low speed, move the speed-selector lever to
the R position.
EARWARD
WARNING
If you move the speed-selector lever while
the traction unit is in motion, the traction
unit will either stop suddenly or accelerate
quickly. If you operate the traction unit with
the speed-selector lever in an intermediate
position, the traction unit will operate
erratically and may be damaged. You could
lose control of the traction unit and injure
bystanders or yourself.
• Do not move the speed-selector lever when
the traction unit is in motion.
• Do not operate the traction unit when
the speed selector is in any intermediate
position (i.e., any position other than fully
forward or fully rearward).
15
Figure 8
2. Loader-valve lock
(disengaged)
position because it does not
position.
g005955