Safety Standards Compliance; Emc, Emi, And Esd Standards Compliance; Energy-Related Products Standby And Off Modes Compliance - Nokia 7368 Product Manual

ANSI CPE safety guidelines

2.2 Safety standards compliance

This section describes the CPE compliance with North American safety standards.
2.2.1
The customer premises equipment complies with the following requirements:
•
This equipment has been tested and found to comply with the limits for a Class B
However, there is no guarantee that interference will not occur in a particular
•
•
•
•
2.2.2
Hereby, Nokia declares that the G-240W-J devices are in compliance with the
18
Warning —
approved by the party responsible for compliance could void the
user's authority to operate the equipment.

EMC, EMI, and ESD standards compliance

Federal Communications Commission (FCC) CFR 47, Part 15, Subpart B, Class
A requirements for equipment
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications.
installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following
measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the
receiver is needed.
Consult the dealer or an experienced radio/TV technician for help.
Energy-related products standby and off modes
compliance
essential requirements and other relevant provisions of Directive 2009/125/EC
3FE-48009-AAAA-TCZZA
Changes or modifications to this unit not expressly
7368 ISAM ONT G-240W-J Product Guide
Issue: 01