Bosch Rexroth IPC 40.2 Project Planning Manual page 52

8-8
Maintenance and Installation
8. Then, snap in the cover again.
9. Now, mount the slot cover.
10. Plug in the battery cable again.
Risk of destruction of the extension card or the
main board!
⇒ The combined PCI/ISA bus slot must never be
equipped with a PCI card and an ISA card at the
CAUTION!
same time!
If the card is equipped with a Plug and Play (PnP) function, it is
automatically recognized by the operating system and integrated in the
system, provided that no hardware conflicts (IRQ etc.) with other
extension cards or connected devices occur.
In the event that after a system reboot the functions based on the new
card are not available, there may be several reasons:
• The card is not properly seated in the PCI or ISA slot.
• The driver software of the card has not been installed or its installation
is faulty.
• IRQ (Interrupt) conflict with other PC hardware components.
• The software of the card has not been installed.
Risk of destruction of the main board or the ISA
card because of address conflicts (IRQ, memory
access, I/O address)!
Observe the information provided by the card
⇒
CAUTION!
manufacturer.
configurations in the BIOS and the operating system
(e. g. Control Panel of NT).
You may have to
DOK-SUPPL*-IPC*40.2***-PR02-EN-P
IPC 40.2
set new