Belt Maintenance; Checking The Condition Of The Hydraulic Pump Belt; Controls System Maintenance; Adjusting The Controls - Toro TX 525 Operator's Manual

Belt Maintenance

Checking the Condition of
the Hydraulic Pump Belt
Service Interval: Yearly
Check the condition of the hydraulic pump belt
52) yearly. Have an Authorized Service Dealer
replace it if it becomes damaged or worn.
Figure 52
1. Hydraulic pump belt
Controls System
Maintenance

Adjusting the Controls

The factory adjusts the controls before shipping the
machine. However, after many hours of use, you
(Figure
may need to adjust the traction control alignment,
the N
EUTRAL
tracking of the traction control in the full forward
position.
Important:
complete each procedure in the order listed.
Adjusting the Traction Control
Alignment
If the traction control bar does not rest flush and
square with the reference bar when in the full
backward position, immediately complete the following
procedure:
1. Park the machine on a level surface, engage the
parking brake, and lower the loader arms.
g004356
2. Shut off the engine and remove the key.
3. Pull straight back on the traction control so the
front of the control contacts the reference bar
(Figure
1. Front of the control (out of
alignment)
4. If the front of the traction control does not rest
square and flush with the reference bar, loosen
the flange nut and bolt in the stem of the traction
control
40
position of the traction control, and the
To adjust the controls properly,
53).
Figure 53
2. Reference bar
(Figure 54).
g004190