Toro TX 525 Operator's Manual page 25

Closing the Hood
1. Lift up on the tab securing the prop rod
25)
Figure 25
1. Prop-rod tab
2. Lower the hood and secure it by pushing down
on the front of the hood until it locks in place.
3. Tighten the hood-locking screw to secure the
latch (Figure 24).
Opening the Rear-Access Cover
1. Unscrew the 2 hand knobs securing the
rear-access cover to the machine
Figure 26
1. Hand knobs
2. Tilt the rear-access cover down and remove to
access the internal components
Closing the Rear-Access Cover
(Figure 1.
2.
3.
Removing the Side Screens
1.
2.
g007360
(Figure 26).
1. Side screen
Installing the Side Screens
Slide the side screens into place in the slots in the
front screen and frame.
g244210
(Figure 26).
25
Move the rear-access cover in place over the
back of the machine; ensure that the tabs line
up in the slots.
Push the access cover forward, lining up the
hand-knob screws with the threaded holes in
the machine.
Screw the hand knobs tight to secure the
rear-access cover in place.
Open the hood.
Slide the side screens
the slots in the front screen and frame.
Figure 27
(Figure 27) up and out of
g004352