Toro 300 Series Setup Instructions page 4

Set-Up Instructions
Checking the Wiring and
Fasteners
Inspect the tractor for any loose electrical
connections and secure as required. Check the
wire routing to make sure no moving parts
interfere with the wires to cause a short.
Check all fasteners to make sure they are tight.
Test Driving the Tractor
1. Check the oil level in the crankcase. Refer to the
Operator's Manual for oil type, viscosity and
crankcase capacity.
Note: When checking the oil level, slide the
dipstick all the way into the filler tube.
2. Check the oil level in the transaxle. Refer to the
Operator's Manual for oil type, viscosity and
capacity.
3. Check to make sure all lubrication points have
been greased as shown in the Maintenance
section of the Operator's Manual. These points
include the front axle pivot and spindles, foot
pedal(s) and steering gear.
4. Fill the tank with unleaded regular gasoline with
an octane rating of at least 85. Open the fuel
shutoff valve and check the fuel hose and fittings
for leaks.
4
5. As applicable, check and test the operation of the
following:
Engine, choke and throttle controls
Gauges
Headlights (and taillights 314 only)
Indicator lights (314 only)
PTO clutch and brake
Lift system
Service and parking brakes
Transmission controls
Steering
Tractor operation in forward and reverse
6. Test the operation of the safety interlock system.
The engine should not crank if:
You are out of the seat
The PTO lever is in the "engaged" position
The gear shift lever is in the "engaged"
position