Toro 300 Series Setup Instructions page 3

4. When the battery is fully charged, unplug the
charger from the electrical outlet, then
disconnect the charger leads from the battery
posts (Fig. 2).
4
Figure 2
1. Positive Battery Post
2. Negative Battery Post
5. Slowly pour electrolyte into each cell until the
level is once again up to the "UPPER" line on
the battery case (Fig. 1), then install the filler
caps.
6. Install the battery in the tractor and connect the
battery cables. (Refer to the Operator's Manual –
Installing the Battery.)
Note: Do not run the tractor with the battery
disconnected, electrical damage may
occur.
2
3
1
3. Red (+) Charger Lead
4. Black (–) Charger Lead
Installing the Drawbar Hitch
Pin
Insert the drawbar hitch pin into the drawbar hitch
and secure it with a
hairpin cotter (Fig. 3).
1254
1. Drawbar Hitch Pin
2. Drawbar Hitch
Attaching the Washer and
Hairpin Cotter onto the Lift Bar
Install a
1/2 x 1"
onto the lift bar (Fig 4).
2
3
1. Lift Bar
2. Flat Washer 1/2 x 1"
Set-Up Instructions
1/2 x 1" flat washer and 1-7/8"
2
4
Figure 3
3. Flat Washer 1/2 x 1"
4. Hairpin Cotter 1-7/8"
flat washer and 1-7/8" hairpin cotter
1
Figure 4
3. Hairpin Cotter1-7/8"
1
3
m–3396
m–2504
3