Table of Contents
Advertisement
How to Flush the Filter After Replacement:
For the CF filter: Turn on the RO faucet to flush for 5 minutes;
For the MRO membrane filter: Turn on the RO faucet to flush for 30 minutes.
NOTE: Turn on the faucet to flush for 30 minutes if replacing the CF filter and
MRO membrane filter at the same time.
Section 4: Malfunction Display
Overworked Reminder:
When the system continuously makes water for more than 30 minutes, the
overworked reminder will be executed and the buzzer will beep for 3 minutes. The
system stops making water when working for over 33 minutes, and the filtering
indicator and power indicator are off. Meanwhile, the CF and MRO filter life
indicators flash red. The system needs to be powered on again to recover itself.
Starting and Stopping Frequently Reminder:
The RO system will perform a starting and stopping frequently reminder when the
booster pump is frequently started and stopped in 20 minutes. The system will
stop making water, while the filtering indicator and power indicator are off and the
CF and MRO filter life indicators flash purple. The system needs to be powered on
again to recover itself.
• If you do not use the machine for a long time (more than 1 week), it is
recommended to turn on the faucet to flush for a while before using it again;
• Please replace the filter regularly according to the filter life indicator;
NOTE: While the testing was performed under standard laboratory conditions,
actual performance may vary depending on the source water quality and
water usage. In case of a premature blockage and failure of the filters, it's
recommended to replace the filter in accordance with actual usage.
• Clean the system with clear water. Do not spray the water directly onto the filter.
Do not use steel wool, an abrasive cleaner or a corrosive liquid such as gasoline
or acetone;
• When cleaning, do not pour other liquids into the filter or you risk damaging the
filter system;
• Keep the waste water pipe unobstructed to avoid damage to the filter or internal
components;
• When the drainpipe is blocked, do not use the system (please turn off the
power) to avoid the waste water from soaking the floor;
• Check the system and water pipe fittings regularly for water leakage to avoid
any property damage;
• Regularly check whether the power supply and wires are damaged or loose to
avoid major accidents caused by electric leakage.
System Maintenance
13
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the G2 Series and is the answer not in the manual?
Questions and answers
How do I recycle the WD-G2MRO Filter and CF Filter?
Why won’t the faucet turn on after having the unit turned off while repairing something else.
The Waterdrop G2 Series faucet may not turn on after repairs if the power under the sink is off or the system is not properly plugged into the power outlet. Check the power connection and try a different outlet to test if the system itself has an issue. If the problem persists, contact customer support for assistance.
This answer is automatically generated