Huawei TP48200A-HX09A2 Installation Manual page 92

TP48200A-HX09A2 & TBC300A-TCA2
Installation Guide
Step 2 Set the IP address, subnet mask, and gateway on the LCD, as shown in
Table 10-6 IP parameters
Main Second-
Menu Level Menu
Setting Network
Wizard Parameters
Step 3 Set the IP Addresses and Ports for the active and standby servers of the NetEco on the LCD,
as described in
Table 10-7 NetEco parameters
Main Second-
Menu Level Menu
Parameters Comm.
Settings Parameters
----End
Networking Mode 2: over RS485 Port
Step 1 Check that the following parameters are set properly: Port Mode to Manual, Protocol Type
to M/S Protocol, Baud Rate to 9600, and Comm. Address to 3.
Table 10-8 Communications parameters
Main Menu Second-
Level Menu
Parameters Comm.
Issue 01 (2013-10-25)
Third-Level
Menu Default Value
IP Address 192.168.0.10
Subnet Mask 255.255.255.0
Default Gateway 192.168.0.1
Table 10-7.
Third-Level Fourth-Level
Menu Menu
Network NetEco Primary IP
Parameters
NetEco Backup IP
NetEco Port
Number
Third-Level Fourth-
Menu Level Menu
Serial Port Northbound
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Setting
Set this parameter according to
the IP address assigned by the
network administrator.
Set this parameter according to
the subnet mask provided by the
network administrator.
Set this parameter according to
the gateway address provided by
the network administrator.
Default Value
192.168.0.10
192.168.0.10
31220
Fifth-Level Default
Menu Value
Port Mode Manual
10 Commissioning
Table 10-6.
Setting
Set an IP address
for the active
NetEco server.
Set an IP address
for the standby
NetEco server.
Set a port for the
NetEco.
Setting
Manual
85