Optional) Setting The Hibernation Parameter; Setting Communications Parameters; Setting Parameters Before Using Webui Management; Optional) Setting Parameters Before Using The Neteco Management - Huawei TP48200A-HX09A2 Installation Manual

TP48200A-HX09A2 & TBC300A-TCA2
Installation Guide

10.6 (Optional) Setting the Hibernation Parameter

Set Hibernation Enable to Yes if you need to use the intelligent hibernation function of the
rectifiers.
Table 10-4 Setting the hibernation parameter
Main Menu
Parameters Settings

10.7 Setting Communications Parameters

10.7.1 Setting Parameters Before Using WebUI Management

Procedure
Step 1 Apply to the site or equipment room network administrator for a fixed IP address.
Step 2 Set the IP address, subnet mask, and gateway on the LCD, as shown in
Table 10-5 IP parameters
Second-
Main Menu Level Menu
Setting Network
Wizard Parameters
----End
10.7.2 (Optional) Setting Parameters Before Using the NetEco
Management
Networking Mode 1: over FE Port
Step 1 Apply to the site or equipment room network administrator for a fixed IP address.
Issue 01 (2013-10-25)
Second-Level Third-Level
Menu Menu
Energy Saving Hibernation Enable
Third-Level
Menu
IP Address
Subnet Mask
Default Gateway
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Default Value
No
Default Value Setting Value
192.168.0.10 Set this parameter according to
the IP address assigned by the
network administrator.
255.255.255.0 Set this parameter according to
the subnet mask provided by the
network administrator.
192.168.0.1 Set this parameter according to
the gateway address provided by
the network administrator.
10 Commissioning
Setting Value
Yes
Table 10-5.
84