Mitsubishi Electric MP-G10-AH Technical Manual page 14

6.4 Creating the stitching data
Refer to the pattern in Fig. 1, and set points A
to G as shown in Fig. 3.
(1) Press
screen.
(2) Press the menu icon
Input Mode screen will open.
(3) Select
speed and stitch length.
Press
Input Mode screen will open.
(If there is no stitching data in the internal
memory,
(4) Input dry feed from the home position to point A with the arrow keys, and
then press
(5) Next using the arrow keys, input point B
→ point E
(6) Press
reopen.
(7) Using the arrows keys, input point F
→ point B
(8) Select
(9) W hen
This completes creation of the stitching data.
on the operation panel's standard
, and set the stitching data type,
, and then press
will not appear.)
.
. Then, select
(reverse signal), and press
.
, and then press
is pressed, the stitching data will be created and written in.
Home position
. The Pattern
. The Arrow
→ point C
. The Code Input screen will open.
. The Arrow Input screen will
→ point G
.
- 12 -
Reverse
Fig. 3
→ point D
→ point A