Handshake Function - Toshiba TLCS-900/H1 Series Manual

Original cmos 32-bit microcontroller

Hide thumbs Also See for TLCS-900/H1 Series:

Table of Contents

Handshake function

errors can be avoided. The handshake functions is enabled or disabled by the

SC0MOD<CTSE> setting.

transmission is halted until the

interrupt is generated, and it requests the next data send to from the CPU. The

next data is written in the transmission buffer and data sending is halted.

Though there is no

setting any port assigned to be the

"high" to request send data halt after data receive is completed by software in the

RXD interrupt routine.

Timing to writing to the

transmission buffer

Send is suspended

from (1) and (2)

Note 1: If the

transmission.

Note 2: Transmission starts on the first falling edge of the TXDCLK clock after the

pin allows data can to be sent in units of one frame; thus, overrun

pin goes high on completion of the current data send, data

Figure 3.14.6 Handshake function

signal goes High during transmission, no more data will be sent after completion of the current

Figure 3.14.7

pin goes low again. However, the INTTX0

pin, a handshake function can be easily configured by

function. The

(Clear to send) Timing

should be output

signal has fallen.