Advertisement
3
Routing the Wire Harness
Parts needed for this procedure:
1
Wire harness (3 connections)
1
Wire harness (7 connections)
1
Fuse (10 A)
For a Groundsmaster 3320/3280-D
Machine (Serial Numbers 250000001
through 259999999)
Note: Use the wire harness with 3 connections.
1. Install the accessory relay connector from the
traction-unit wire harness into the power relay
12).
1
2
1. To ground (black)
2. To fuse block (yellow)
G018074
1. Accessory relay connector 3. Black wire
2. Large, red wire
2. Connect the large, red wire
auxiliary fuse block to the mating connector from the
traction-unit harness.
(Figure
3. Connect the power point connector from the kit wire
harness to the power point.
4. Connect the yellow wire to an open lead on the fuse
block
(Figure
5. Attach the black wires from the traction-unit wire
harness and the kit wire harness to the ground block
(Figure 12
6. Insert a 10 A fuse into the fuse block slot for the
yellow wire.
7. Install the control panel and secure it with the
thumbscrews that you previously removed.
8. Connect the negative battery cable to the battery.
Note: When the kit is properly installed, the power
point and fuse block should only have power when the
traction-unit ignition switch is in the O
G018077
Figure 13
3. To power point
5
Figure 12
(Figure
12) from the
13).
and
Figure
13).
3
position.
N
Advertisement
