Advertisement
Quick Links
Auxiliary Power Unit
Groundsmaster
Model No. 30382
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
1
Preparing the Machine
No Parts Required
Procedure
1. Move the machine to a level surface (box A of
2. Engage the parking brake (box B of
3. Remove the key from the ignition switch (box C of
4. Remove the negative battery cable from the battery (box D of
© 2016—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
®
3320/3280-D and 7200/7210 Traction Units
Description
No parts required
Power relay
Locknut
Screw
Fuse block
Ground block terminal
Jumper strip
Power point
Cap
Wire harness (3 connections)
Wire harness (7 connections)
Fuse (10 A)
Figure
1).
Register at www.Toro.com.
Qty.
–
1
5
5
1
1
1
1
1
1
1
1
Figure
1).
Figure
1).
Figure
1).
Figure 1
Form No. 3406-911 Rev A
Installation Instructions
Use
Prepare the machine.
Install the power unit.
Route the wire harness.
Original Instructions (EN)
All Rights Reserved *3406-911* A
Printed in the USA
Advertisement
Summary of Contents for Toro 30382
- Page 1 Form No. 3406-911 Rev A Auxiliary Power Unit Groundsmaster ® 3320/3280-D and 7200/7210 Traction Units Model No. 30382 Installation Instructions Loose Parts Use the chart below to verify that all parts have been shipped. Procedure Description Qty. – No parts required Prepare the machine.
-
Page 2: Installing The Power Unit
2. Mount the ground terminal block to the bottom of the compartment with 2 screws and 2 locknuts (Figure Note: Do not use the locknuts if flat nuts exist on the bracket. Installing the Power Unit Parts needed for this procedure: Power relay Locknut Screw... - Page 3 For a Groundsmaster 7200/7210 5. Mount the power relay to the flat nut on the side of the compartment with a screw (Figure Machine Note: Use a locknut if there is no flat nut. You may 1. Unlatch and raise the seat. need to remove the 4 screws securing the mounting 2.
- Page 4 Note: Install the screws from the underside of the panel as shown in Figure Figure 11 1. Power point in knockout 2. Cap location 8. Unscrew the outer shell from the threaded power point Figure 9 connector body. 1. Locknut 3.
- Page 5 Routing the Wire Harness Parts needed for this procedure: Wire harness (3 connections) G018074 Wire harness (7 connections) Fuse (10 A) Figure 12 1. Accessory relay connector 3. Black wire For a Groundsmaster 3320/3280-D 2. Large, red wire Machine (Serial Numbers 250000001 through 259999999) 2.
- Page 6 For a Groundsmaster 3320/3280-D Note: Make sure that the fuses are installed in the slots that have wires connected to the harness. The (Serial Numbers 260000001 and up) or remaining fuse block wires are not used at this time. Groundsmaster 7200/7210 Machine 5.
- Page 7 Notes:...