Installing The Power Unit - Toro 30382 Installation Instructions Manual

2

Installing the Power Unit

Parts needed for this procedure:
1 Power relay
5 Locknut
5 Screw
1 Fuse block
1 Ground block terminal
1 Jumper strip
1 Power point
1 Cap
For a Groundsmaster 3320/3280-D
Machine
1. Remove the 4 thumbscrews securing the control-panel
plate to the machine
Note: The mounting holes required for the installation
of the components are already in the control-panel
compartment.
G018073
1. Control-panel plate
2. Thumbscrew
(Figure 2).
Figure 2
3. Knock-out plug
2. Mount the ground terminal block to the bottom of the
compartment with 2 screws and 2 locknuts
Note: Do not use the locknuts if flat nuts exist on
the bracket.
1. Screw
2. Ground terminal block
3. Mount the jumper strip to the ground terminal using 2
of the ground terminal block screws.
4. Mount the fuse block to the side of the compartment,
above the existing fuse block, with 2 screws and 2
locknuts (Figure
Note: Do not use the locknuts if flat nuts exist on
the bracket.
Fuse block wires not shown
1. Fuse block
2. Screw
2
Figure 3
3. Locknut
4. Front direction
4).
Figure 4
3. Locknut
(Figure 3).