Advertisement
5. Mount the power relay to the flat nut on the side of the
compartment with a screw
Note: Use a locknut if there is no flat nut. You may
need to remove the 4 screws securing the mounting
panel and pull up the mounting panel to install the
locknut.
Figure 5
1. Power relay
6. Remove the knock-out plug from the side of the
control-panel plate
(Figure
7. Unscrew the outer shell from the threaded power point
connector body.
8. From the seat side of the control-panel plate, insert the
power point into the hole, secure it with the outer shell,
and insert the cap into the power point
Figure 6
1. Control-panel plate
2. Cap
(Figure
5).
2. Screw
2).
(Figure
6).
3. Power point
For a Groundsmaster 7200/7210
Machine
1. Unlatch and raise the seat.
2. Unlatch the control-panel assembly and lay it aside
(Figure
7).
G018078
1. Control-panel assembly
3. Mount the ground terminal block to the bottom of the
control-panel assembly with 2 screws and 2 locknuts
(Figure
8).
Note: Install the screws from the underside of the
panel as shown in
1. Control-panel assembly
2. Locknut
4. Mount the jumper strip to the ground terminal using 2
of the ground terminal block screws.
5. Mount the fuse block to the bottom of the
control-panel assembly, next to the existing fuse block,
with 2 screws and 2 locknuts
3
Figure 7
2. Latch
Figure
8.
Figure 8
3. Screw
(Figure
9).
Advertisement
