Table of Contents
Advertisement
Light
Blue
Yellow
Red
Blue Flash
Red Flash
Section 3: Filter Replacement Guide
NOTE: If filter expires, please purchase and replace filter immediately. Otherwise, the
filtration efficiency will decrease significantly and affect the performance.
How to Replace Filters:
The filters could be replaced directly without cutting off power and water, and there will be
no water and electric leakage.
1. Twist off the filter that needs to be replaced in counterclockwise direction (Figure 28).
NOTE: After replacing CF and CB filter, it's recommended to press the center knob (Figure
29) protruding at the top of the old filter to release pressure to avoid water spills. Get a
towel or bucket to catch any water drips;
2. Twist the new filter into the housing in clockwise direction;
3. Reset filter life indicator and flush the filter after replacement (Please refer to the
following steps).
How to Reset Filter Life Indicator (Taking Reset of CB Filter Life Indicator
for Example):
Press and hold the CB filter life indicator for 7 seconds until the system beeps.
NOTE: The filter life reset of CF and RO is the same as the reset of CB.
Remaining Life(Day)
>15
≤15
≤ 0
/
/
Figure 28
Remaining Capacity (G)
>40
≤40
≤ 0
/
/
14
Status
Good
Replace Soon
Replace Now
Flushing
Malfunction
Figure 29
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the WD-G3-B and is the answer not in the manual?
Questions and answers
We accidentally left the water faucet on filling up a picture. When we came back, the water system was completely off and the control display was black. After an hour or so the display came back on linking and there’s an error code E03. Please advise on what we should do to get the system back on. Also to turn the water on at the Waterdrop faucet should they handle be down position for on an up position for off? It also shows that the second filter is blinking red on the faucet control display however, on the unit all indicators show Should we replace the filter? Thank you, Janice Elder. We have a Waterdrop G3. My phone number is 408-799-3545.
To resolve error code E03 on the Waterdrop G3 system, which indicates that the booster pump has overworked and the buzzer beeps for 3 minutes, the system must be powered on again to recover.
For proper operation, the faucet handle should be turned on when using the system.
If the second filter is blinking red on the faucet control display, it should be replaced immediately as it has expired.
This answer is automatically generated
What do the numbers mean on the faucet face plate
Does the WD-G3-W flush for 15-20 seconds after EVERY use? Mine does.
What does the single digit of 5 or any number mean/represent in the TDS ; I understand what tds stands for ; what does the number mean, thnx