General Cleaning; Trouble Shooting - Aqualisa SIERRA Installation And User Manual

3. To select the desired spray pattern rotate the shower spray plate clockwise
or anti-clockwise.
Inlet filters
The product is protected by inlet filter washers located in the inlet
elbow connections.

GENERAL CLEANING

Whilst modern plating techniques are used in the manufacture of these
fittings, the plating will wear if not cleaned properly. The safest way
to clean your product is to wipe with a soft damp cloth. Stains can be
removed using washing up liquid.
DO NOT USE ABRASIVE CLEANERS.
Limescale
Rub the nozzles of the shower head to break down scale build up. Should
chemical descaling of the head become necessary, remove the shower
head fully and immerse in a mild proprietary descaler.
IT IS IMPERATIVE THAT DESCALING IS CARRIED OUT STRICTLY
IN ACCORDANCE WITH THE MANUFACTURERS INSTRUCTIONS.
SUBSTANCES THAT ARE NOT SUITABLE FOR PLASTICS AND
ELECTROPLATED SURFACES MUST NOT BE USED.

TROUBLE SHOOTING

Symptom
Water leaking
from shower
head.
Maximum water
temperature too
hot or cold.
18
Possible Cause
This is normal for a short time after
turning off.
Shower flow valve failing to close
fully, possibly due to water borne
debris.
Maximum water temperature set
incorrectly.
Remedy
Adjust angle of shower head
in holder as necessary to vary
draining time. Clean shower head.
Remove cartridge and check.
See pages 15-16 before dismantling
shower valve.
Reset maximum water temperature.
See pages 14-15.