Table of Contents
Advertisement
Network features
You may connect your multifunction terminal to an
Ethernet or a wireless network.
However,
practical
knowledge
configuration is required to set up a network.
Selecting the type of your local
network
This parameter allows you to configure your terminal
accordingly to the type of network you will install it in.
26 - SETUP / LOCAL NETWORK
1 Select the desired network type using the
buttons
- WLAN if using a wireless network
- LAN ETHERNET if using a wired network
2 Confirm with OK.
Ethernet network settings
Automatic configuration
We recommend that you carry out a manual configuration
of your terminal. The automatic configuration of the local
network settings may be considered, if your local network
features a DHCP or BOOTP server that can dynamically
assign addresses to the peripheral devices present on the
LAN.
To automatically configure the local network settings:
2711 - SETUP / LAN ETHER / PARAMETERS / IP
1 Choose Automatic and press OK to confirm. The
terminal scans the local network for a DHCP or
BOOTP server that can assign it its settings
dynamically (the message S
displayed).
2 Once the message S
check for the IP Address, Sub-network mask and
Gateway address. If these are missing, you should
carry out a manual configuration (see below).
Manual configuration
To configure your terminal manually, you should obtain
the usual information used to set a peripheral device (IP
address, sub-network mask, network and gateway
address).
of
your
computer
or
CONFIG.
-
is
ELF
CONF
-
has disappeared,
ELF
CONF
To configure the local network setting manually:
2711 - SETUP / LAN ETHER / PARAMETERS / IP
1 Choose Manual and press OK to confirm.
IP address
2712 - SETUP / LAN ETHER / PARAMETERS / IP
1 Enter the IP address of your terminal and press OK
to confirm.
Sub-network mask
2713 - SETUP / LAN ETHER / PARAMETERS /
1 Enter the sub-network mask of your terminal and
press OK to confirm.
Gateway address
2714 - SETUP / LAN ETHER / PARAMETERS /
1 Enter the IP address of the network gateway and
press OK to confirm.
IEEE Address (or Ethernet address) or MAC
address
2715 - SETUP / LAN ETHER / PARAMETERS / IEEE
The Ethernet card of your terminal already has an
unmodifiable, yet consultable, IEEE address.
NetBIOS names
These names, which can be used with the network
options, are used to identify your terminal machine from a
PC connected to a local network (for instance with the
name "IMP-NETWORK-1").
2716 - SETUP / LAN ETHER /PARAMETERS /
2717 - SETUP / LAN ETHER / PARAMETERS /
1 Enter the selected name (15 characters max) and
press OK to confirm.
Name servers
The WINS1 and WINS2 servers, used with the network
options, allow access to terminals on other sub-networks
by means of their NetBIOS name.
These two addresses must be filled in
Note
for the Scan To Disk function.
- 47 -
LFF6080
CONFIG.
ADDRESS
SUBNET MASK
GATEWAY
ADDRESS
NETBIOS 1
NETBIOS 2
Advertisement
Table of Contents
