Fujitsu MB904 Series Application Note page 20

Chapter 4 Set-up Debug Configuration
After the set-up wizard is finished, the debugger can be started with its configured settings.
In the browser window the default debugger is marked with a blue colour. The debugger is
started via double-click on the item in the browser window or via the <Debug>, <Start
debug> menu.
To change the debug set-up just use the right mouse button on the corresponding debug
item in the browser menu. This will open a drop down menu to modify/delete the debug set-
up.
When the debugger is started the first time, the firmware will be downloaded automatically.
This will be indicated by the following information box.
A load debug file notification will be displayed afterwards and the debug source window is
opened, ready to set breakpoints, open watch-, register, memory- window, ...
Now first remove the selection "Monitor-load auto-program" in the emulator setup,
before you start further debugging (described on page 18).
MCU-AN-390077-E-V11 - 20 - © Fujitsu Microelectronics Europe GmbH